Table of Contents
Advertisement
BEFORE PROGRAMMING
PROGRAMMING OUTLINE
Indicates the range of the Exchange line
No. (MODE 2), extension Style No. (MODE 3)
or extension No. (MODE 4-7)
Address No.
(01-04)11#-(0, 1-3)#
EXTERNAL RING OUTPUT
You can ring an incoming ringing tone from
Function name
an external speaker.
To set when (Day/Night) to ring.
Description
of function
0#: Does not ring
1#: Rings only in Day mode
2#: Rings only in Night mode
3#: Rings in both Day and Night mode
Initial setting
item
Data setting item
IMPORTANT
C: The data copy is available for items with this mark.
P: Power setting is required for items with this mark.
M: Two or more setting can be assigned with this mark.
POWER SETTING using ON/OFF Switch:
There are four exceptions to programming from the administrator's telephone. The following
addresses can be only be programmed using the POWER SETTING:
MODE 1 - addresses:
To change the data in the addresses above, perform the following steps:
1 Power ON
d
2 Enter data
d
3 Power OFF
d
4 Power ON
After POWER SETTING, the data has been changed.
Data set range
( 0 1 - 0 4 : Exchange
CP
ine N o . )
l
0001# (EXCHANGE LINE)
0313# (SLT ON HOOK DETECTION TIMER)
0412# (SYSTEM SPEED DIAL)
0419# (OFF-HOOK MONITOR)
P-12
Basic operation
C, P, M marks
PROGRAMMING (MODE 2)
( 0 1 - 0 4 : Exchange
(01-04)14#-(0, 1-7)#
INCOMING RING SIGNAL DETECTION TIME
Detects an incoming ring signal when the
signal is longer than the time programmed for
an incoming ring signal. For example, if the
time programmed of an incoming call signal is
200 mseconds or longer, signal that are longer
than 200 mseconds are identified as a phone
call. Any signal shorter than 200 mseconds are
not considered phone signal and are disre-
garded.
Data setting value
ine N o . )
l
Advertisement
Chapters
Table of Contents
