MULTIQUIP QP3TB Operation Manual page 18

3. If starting a cold engine, place the engine choke lever
in the CLOSED position (Figure 10).
CHOKE
LEVER
Figure 10. Choke Lever (Closed)
4. If starting a warm engine, place the engine choke
lever in the OPEN position (Figure 11).
CHOKE
LEVER
Figure 11. Choke Lever (Open)
5. Slowly pull the starter grip (Figure 12) until resistance
is felt, then pull briskly and smoothly to start the engine.
Gently return the starter grip to its original position.
STARTER
GRIP
Figure 12. Starter Grip
6. If the engine has started, slowly return the choke lever
to the OPEN position (Figure 11) as the engine warms.
If the engine has not started, repeat steps 1–5.
PAGE 18 — QP3TB TRASH PUMP • OPERATION MANUAL — REV. #0 (12/08/22)
7. Run the engine at idle for several minutes and check
for any abnormal conditions such as extreme vibration,
loose components, or fluid leaks.
8. To begin pumping, place the engine throttle lever
(Figure 13) in the RUN position.
THROTTLE
LEVER
Figure 13. Throttle Lever (Run)
WARNING
Water must always be flowing through the pump
casing while the engine is running. Loss of flow may
be the result of a loss of prime, restricted water flow,
or a dead-head situation. Please note that in such a
condition, water in the pump can reach temperatures
of 150–200°F in 15–20 minutes. This can cause
serious burns if this hot water comes into contact with
unprotected skin.
Before touching or opening the fill plug or drain plug,
first turn off the engine and allow the pump casing to
cool to the touch, then open the pump carefully. Be
cautious of any built-up water pressure.
CAUTION
ALWAYS run the engine at full speed while pumping.
OPERATION