4. Troubleshooting
1.
TV in Standby
Check
Standby LED Indicator
9
2.
If Not Lit:
Check One Connect Box is Powered.
9
•
If OK
Check OCB Cable to TV (Miss Connections or damaged cable)
9
•
If OK
Check
A13V
9
•
A13V is supplied from One Connect to SMPS & TV Board
3.
If A13V is missing on
•
Remove
CNM803A Connector to LD/SMPS A
Check A13V on Cable or at TV Board
9
•
If A13 is now OK & Standby is now On, Replace Defective SMPS
•
If A13 is still missing
Check One Connect Operation / One Connect Cable
9
•
Perform One Connect Power Supply Stand Alone Test
•
If OK Replace defective One Connect Cable or TV Main Board
4.
If A13 was OK on
LD/SMPS A
Check TV Main Board supply voltages to Function Control
9
•
If missing replace TV Main Board
Check Standby LED voltage (1.7Vdc on Function Connector)
9
•
If OK replace Function Assy
•
If missing replace TV Main Board
4-4
CNM803A Pin 17 on TV LD/ SMPS A
LD/SMPS A