Benq Launcher - BenQ EU610ST User Manual

BenQ Launcher

BenQ Launcher is the projector's operating system that allows you to wirelessly cast your
device's screen, create video conferences, play files, run apps, as well as adjust projector
settings.
Use the buttons on the projector, the remote control, or connect a USB mouse to the projector's USB-1,
USB-2, or USB-3 ports to navigate BenQ Launcher and operate its functions.
The BenQ Launcher home screen
Upon initial start up or when BenQ Launcher is selected in the input source menu, the projector
will display BenQ Launcher. If the projector is projecting from an input source (e.g. HDMI or
PC), you can return to BenQ Launcher mode by pressing the source button
LAUNCHER button on the remote control and then selecting BenQ Launcher in the input source
menu.
When the Auto Source Search function is enabled in the Settings menu of the projector's OSD menu, the
projector will display the BenQ Launcher home screen by default every time it is powered on. If the Auto
Source Search function is disabled, the projector will detect if a signal is available from the input source
that was last used and switch to that input source if it is available, if a signal is not available or the projector
was set to BenQ Launcher during the previous session, the projector will enter the BenQ Launcher home
screen. See Switching input signal on page
1
2
3
4
5
6
Actual screen may vary based on your BenQ Launcher firmware version.
74.
or the
Operation (under Launcher source)
2
7
8
33