Table of Contents
Advertisement
Troubleshooting
60
Downloaded from:
https://www.usersmanualguide.com/
PROBLEMS
- See if the power cord became unplugged.
There is no power
.
- Check for a blown fuse or circuit breaker or a power outage.
- The antenna could be disconnected.
There is no picture
- The input mode (TV/Video) could be set improperly. See page 58.
or sound
- The tuner (AUTO TUNER SETUP) could be set improperly. See page 29.
- The TV station may be having difficulties. Check to see if other stations are
working.
- Check to see that the batteries are still working and properly installed.
Remote control is not
- Make sure the remote has a clear sight path to the TV.
operating properly
- Check that the TV/CATV switch is in the proper position.
or at all
- You may be too far from the TV. You must be within 23 feet (7 meters).
- Use the remote control while pointing it at the screen.
- Make sure the channels have been programmed. See "Channel Summary"
You cannot select a
page 32.
certain channel
- Check to see if the channel is locked. See "Channel Summary - Lock" page 32.
- Make sure the set did not become unplugged.
The power turns off
- Perhaps the ON/OFF TIMER is set. See page 48.
by itself
- Check to see if the Sleep Timer was set. See page 55.
It does not operate
This television is operated by a microprocessor. It is possible that external noise
correctly
or interference is causing the problem. If the television does not function correctly,
remove the electric plug from the wall outlet and wait a while before inserting it
into the wall outlet again and operating the television.
The power was interrupted and the clock was not reset. See page 30.
The clock is wrong
The color quality is poor
- Tint and Color may be improperly adjusted. See page 42.
- The VIDEO STATUS mode may be turned to the wrong setting. See page 56.
- If red, green and blue shadows appear on the contours of the image on the
screen, it is necessary to adjust the CRT color convergence. See page 52.
There are lines across
There could be interference from another electrical appliance, such as a
the picture
computer, another TV or VCR. Move any such appliances further away from
the TV.
The picture is spotted
There could be interference a from high-wattage appliance, like a hairdryer or
vacuum, operating near-by. Move the antenna away from the appliance or
change to a coaxial cable connection which is less prone to interference.
CHECK
Advertisement
Table of Contents
