Connecting To Cable Or An Antenna - JVC AV-56WP30/A User Manual

Connecting to Cable or an Antenna

There are three basic types of antenna or cable connections:
•
•
•
•
•
•
Diagram #1
1) Connect an RF Cable from the wall outlet into the RF Cable In on the back of the TV.
Connecting to a Cable Box
Diagram #2
1) Connect an RF Cable from the wall outlet into the RF Cable In on the Cable Box.
2) Connect an RF cable from the Cable Out on the cable box into the RF Cable In on the back
NOTE:
•
Downloaded from: https://www.usersmanualguide.com/
If you have an antenna or have a cable system that does not require you use a cable
box to select channels, please refer to Diagram #1.
If you have a cable system that requires the use of a cable box to access all the
channels, please refer to Diagram #2.
If you have a cable system that requires the use of a cable box to access certain
premium channels, but not "basic" cable channels, please refer to Diagram #3.
For your convenience, connection to a VCR is also shown in the following diagrams. A
VCR is not necessary for operation of the television or Picture OUT or Picture POP
function. You may omit the VCR from your connections if you wish.
For instructions on connecting a VCR only, please see the Quick Setup on page 10.
For information on using POP, please see page 54.
TV Rear Panel
(RF Input)
75Ω
(VHF / UHF)
TV Rear Panel
(RF Input)
75Ω
(VHF / UHF)
of the TV.
Please see page 54 for more information on using the POP feature with a cable box.
Connections
Cable or Antenna
Output
Cable/RF connector
Cable or Antenna
Output
Cable Box
OUT IN
13