Remove Bumper & Heat Shield Assembly; Install Bagger Mounts, Bumper & Heat Shield Assembly - Gravely 892051 Operator's Manual

REMOVE BUMPER & HEAT
SHIELD ASSEMBLY
1. Remove two hex bolts, three washers,
and two nyloc nuts from each corner of
bumper. Retain hex bolts and small
washers. Discard nyloc nuts and large
washer. See Figure 4.
Figure 4
2. Pro-Turn 200 Models: Remove and retain
two screws and remove bumper and heat
shield assembly. See Figure 5.
Bumper
Figure 5
3. Pro-Turn 400 Models: Remove and retain
two lower and four upper screws and
remove bumper and heat shield
assembly. See Figure 6.
INSTALL BAGGER MOUNTS,
BUMPER & HEAT SHIELD
ASSEMBLY
1. Slide left bagger mount (item 8) and right
Heat Shield
2. Reinstall bumper and heat shield
EN - 10
Heat Shield
Figure 6
bagger mount (item 7) onto the frame
rails. See Figure 7.
8
7
Figure 7
assembly. Secure with four retained hex
bolts, four retained washers, and four
nyloc nuts (item 9). Do not fully tighten.
See Figure 8.
Bumper