Assembly - Gravely Promaster 260Z Owner's/Operator's Manual

WARNING: AVOID INJURY. Read and understand
the entire Safety section before proceeding.
Unpack Unit
Remove unit and all other components from shipping container.
Open bypass valves (see Moving Unit Manually on page 14).
Push unit from container onto a level surface. Close bypass
valves.
Prepare Seat
Remove nuts from seat studs in hood frame. Peel off paper
backing from foam tape and place between hood frame and
chassis. Lift and rotate seat onto hood frame. Secure with nuts.
Install Steering Levers
Remove bolts and spacers from steering rod. Flip steering
levers up into operating position. Reinstall spacers, bolts,
and nuts. Tighten hardware securely (figure 3).
2
1
1. Steering Lever in
Shipping Position
2. Spacers and Hardware
2
3
3. Steering Lever in
Operation Position
Figure 3

ASSEMBLY

Install Deflector
WARNING: Deflector must pivot freely. DO NOT
overtighten pivot bolts.
Remove, reverse, and reinstall deflector and mounting
bracket.
Check Tire Pressure
See Specifications on page 30.
Check Engine Oil
Refer to Engine Manual.
Check Hydraulic Oil
See Checking Hydraulic Oil Level on page 25.
Check Coolant Level
See Checking Coolant Level on page 26.
Fill Fuel Tank
See Filling Fuel Tank on page 14.
Connect Battery
Place hood in the full service position (see Service Positions
on page 17). Connect negative (–) battery cable to battery.
(see Battery Removal and Installation on page 18 and
perform steps 2 through 4 in the installation section).
Level Mower Deck
See Leveling the Mower Deck on page 20.
Check Safety Interlock System
WARNING: Safety interlock system failure and
improper operation of unit can result in death or
serious injury. Test this system each time unit is
operated. If this system does not function as
described, do not operate until repairs are made.
OF3224
See Check Safety Interlock System on page 10.
Check Function of All Controls
Ensure unit runs and performs properly.
GB - 10