Table of Contents
Advertisement
INTRODUCTION
The AC405SS variable speed (550-1,600/min) scroll saw comes
with a powerful DC motor and can easily cope with cutting a
wide variety of materials up to 50mm deep. The two blade
arms are independently pivoted giving a virtually straight
up-and-down motion to the blade for a better quality cut.
A 35mm diameter dust port allows the scroll saw to be
connected to a vacuum cleaner. A generous table (410 x
GENERAL SAFETY INSTRUCTIONS FOR 230V MACHINES
The following will enable you to observe good working
practices, keep yourself and fellow workers safe and maintain
your tools and equipment in good working order.
WARNING!! KEEP TOOLS AND EQUIPMENT
OUT OF REACH OF YOUNG CHILDREN
KEEP WORK AREA AS UNCLUTTERED AS IS PRACTICAL.
UNDER NO CIRCUMSTANCES SHOULD CHILDREN BE
ALLOWED IN WORK AREAS.
Mains Powered Tools
• Tools are supplied with an attached 13 Amp UK 3 pin plug,
fitted with 5 amp fuse.
• Inspect the cable and plug to ensure that neither are
damaged. Repair if necessary by a suitably qualified person.
• Do not use when or where it is liable to get wet.
Workplace
• Do not use 230V a.c. powered tools anywhere
within a site area that is flooded.
• Keep machine clean.
• Leave machine unplugged until work is about to commence.
• Always disconnect by pulling on the plug body and not the
cable.
254mm) with a 406mm (16") throat, tilts to 45° for bevel
cutting. The saw accepts pinned or plain end blades. The clamps
are easily accessible for blade changing. A blower helps keep
the cutting line clean and easily seen. When changing blades a
quick release tension knob allows quick and easy change. The
heavy cast iron base gives stability and ensures low vibration.
• Carry out a final check e.g. check the cutting tool
is securely tightened in the machine and the correct
speed and function set.
• Ensure you are comfortable before you start work,
balanced, not reaching etc.
• Wear appropriate safety clothing, goggles, gloves,
masks etc. Wear ear defenders at all times.
• If you have long hair wear a hair net or helmet to prevent it
being caught up in the rotating parts of the machine.
• Consideration should be given to the removal of rings and
wristwatches.
• Consideration should also be given to non-slip footwear etc.
• If another person is to use the machine, ensure they are
suitably qualified to use it.
• Do not use the machine if you are tired or distracted
• Do not use this machine within the designated safety areas
of flammable liquid stores or in areas where there may be
volatile gases.
• Check cutters are correct type and size, are undamaged
and are kept clean and sharp, this will maintain their
operating performance and lessen the loading on the
machine.
• OBSERVE.... make sure you know what is happening
around you and USE YOUR COMMON SENSE.
4
Advertisement
Table of Contents
