Rheem PRO+G48-60N RH60 Use & Care Manual page 14

Installing the water heater.
14
During Installation of this water heater...........
DO
DO check inlet gas pressure to ensure
❑
that it is within the range specified on the
rating plate.
DO provide adequate air for combustion
❑
and ventilation as discussed in the Use and
Care Manual and the National Fuel Gas
Code.
DO maintain proper clearances to
❑
combustibles as specified on the rating plate.
DO ensure that the venting system
❑
complies with the guidelines found in the
Use and Care Manual and National Fuel Gas
Code.
DO contact a qualified service technician
❑
if the pilot or main burner will not stay
lit. The burner chamber is designed to be
sealed utilizing a gasket and tamper resistant
screws.
DON'T
DON'T block or restrict Combustion
❑
Air Inlet Openings located around the lower
portion of the water heater jacket.
DON'T remove the Burner Access
❑
Door unless absolutely necessary.
should only be done by a qualified service
technician. A new burner access door gasket
must be installed on any burner access door
that has been removed.
DON'T install this water heater where
❑
standing water may occur. The base of the
water heater is meant to be mounted on a dry
surface.
DON'T operate the water heater if the
❑
sight glass or pilot assembly door grommet
is damaged or broken.
Pilot Assembly
Door Grommet
This
Sight Glass