Advertisement
Oil
Gasoline
Fuel mix chart 50 : 1 (2%)
US
GAS
OIL
GAL.
FL.OZ.
1
2.6
2
5.1
5
12.8
NOTE
Starter handle: Use short pulls - only 1/2 - 2/3 of
starter rope for starting. Do not let starter rope
snap back in.
Always hold the unit firmly.
Sholder level
Throttle trigger
OPERATION
1
50
METRIC
GAS
OIL
L
mL
4
80
8
160
20
400
Fuel tank
Ignition switch
Start/Run
Stop
Push
Throttle control lockout
RUN(OPEN)
START(CLOSE)
Choke knob
GENERAL CHECK
• Eneure that all nuts, screws and bolts installed are
properly tightened.
FUEL STATEMENT
GASOLINE: Use 89 octane [(R+M)/2] gasoline or
gasohol known to be good quality. Gasohol may
contain maximum 10% ethyl (grain) alcohol or 15%
MTBE (methyl tertiary-butyl ether). Gasohol
containing methyl (wood) alcohol is not approved.
OIL: ECHO brand premium two-stroke 50 : 1 oil is
requirred.
Mix oil and gasoline /gasohol according to
instructions on the oil container label.
MIXING: Follow directions on the oil container.
NOTE
Stored fuel ages. Do not mix more fuel than you
expect to use in thirty (30) days, ninety (90) days
when a fuel stabilizer is added.
Stored two-stroke fuel may separate. ALWAYS
shake fuel container thoroughly before each use.
STARTING COLD ENGINE
WARNING
• • • • • WHEN ENGINE IS STARTED, CONFIRM IF
THERE IS NOT ANY ABNORMAL
VIBRATION OR SOUND. IF THERE IS
ABNORMAL VIBRATION OR SOUND, ASK
YOUR DEALER TO REPAIR.
• • • • • AFTER REFUELING TIGHTEN FUEL CAP
FIRMLY AND CHECK FOR LEAKAGE. IN
CASE OF FUEL LEAKAGE REPAIR BEFORE
STARTING OPERATION SINCE THERE IS A
DANGER OF FIRE.
• It is not permitted to fill fuel above the shoulder
level of fuel tank.
• Slide switch to START/RUN position as shown.
• Turn choke knob to START (CLOSE) position.
• Pull starter handle until the engine fires. Now, turn
choke knob to RUN (OPEN) position, and if
necessary, restart the engine again and allow to
warm up for a few minutes before using.
• After idling, gradually open throttle and cutter
blade will start to operate as the engine attains
clutch engagement speed of 3,000 r/min
approximately.
STARTING WARM ENGINE
• When engine is warm, start it by pulling starter
handle with switch positioned at START/RUN.
(Keep choke knob in RUN (OPEN) position)
• If engine does not start in a few tries, follow same
procedures as starting a cold.
7
DANGER
Advertisement
