Philips Senseo HD7820 User Manual page 3

Type HD7824 only: the light rings around the 1-cup button q and the 2-cup button
qq indicate if there is still enough water left for brewing one or two cups of coffee.
If there is not enough water left in the water reservoir for brewing two cups of
coffee, the light ring around the 2- cup button qq will not go on and this button
cannot be operated.
The SENSEO coffee machine starts brewing.
,
\
- The machine automatically supplies the optimal amount of water.
- You can interrupt the brewing process at any time by pressing the on/off button
3. If you switch the machine back on after having interrupted the brewing
process, the machine will not complete the interrupted brewing cycle.
Do not remove the water reservoir during a brewing cycle, as this will cause the
machine to draw in air. When this happens, the next cup will only be partly filled.
Types HD7822/HD7820 only: if the cups are only half full when the machine stops
brewing, there was not enough water left in the water reservoir to brew two cups.
To obtain two full cups, fill the water reservoir and press the 1-cup button q. The
two cups will then be filled completely.
Note: If you only get a small quantity of coffee or no coffee at all out of the machine, you
have not flushed the machine properly before first use. As a result, the boiler is not or not
completely filled. Flush the machine properly (see chapter 'Preparing the machine for use')
before you brew another cup of coffee.
10 Remove the coffee pod(s) after use by lifting the pod holder out of the
machine and emptying it.
Be careful when doing this, for there may still be some water/coffee on the coffee
pod(s).
Tips
By rinsing the pod holders, the coffee collector and the coffee spout regularly,
,
you will make sure that the coffee always tastes optimally.
The SENSEO coffee will taste best if you stir it before drinking it.
,
\
If you intend to make another cup of SENSEO
,
coffee machine switched on. The machine will automatically switch itself off
after 1 hour. (Fig. 18)
Cleaning
Never immerse the SENSEO coffee machine in water.
\
Never clean the machine by flushing it with the lid open.
1 Always unplug the machine before cleaning it.
2 Clean the outside of the machine with a moist cloth.
3 Remove the coffee collector. (Fig. 19)
4 Take the coffee spout out of the machine by sliding it upwards. (Fig. 20)
The coffee spout can only be taken out after the coffee collector has been removed.
You can disassemble the coffee spout for more thorough cleaning! (Fig. 21)
,
5 Clean the coffee spout, the coffee collector and the drip tray in hot water, if
necessary with some washing-up liquid, or in the dishwasher. (Fig. 22)
6 Hold the cup tray in your hand while cleaning it with hot water, if necessary
with some washing-up liquid. (Fig. 23)
The cup tray can also be cleaned in the dishwasher.
To clean the cup tray, always remove it from the machine, as it might prove sharp
when handled incorrectly. Always handle it carefully.
7 Clean the pod holders in hot water, if necessary with some washing-up liquid,
or in the dishwasher. (Fig. 24)
Check if the sieve in the centre of the pod holder is clogged. If this is the case, unclog
the sieve by rinsing the pod holder under a running tap. Use a washing-up brush to
clean the sieve, if necessary.
8 Clean the water reservoir in hot water, if necessary with some washing-up
liquid. (Fig. 25)
Note: If you are using a washing-up brush, be careful not to damage the valve in the
bottom of the water reservoir.
9 Do not use an object with sharp edges to clean the water inlet on the
machine. (Fig. 26)
10 Rinse the parts with fresh water after cleaning and put them back into the
machine.
11 Clean the water distribution disc with a moist cloth. (Fig. 27)
Be careful when you do this; make sure that the rubber sealing ring does not get
stuck under the edge of the water distribution disc. If it does, the coffee machine will
start leaking!
Flushing
If you have not used the coffee machine for three days, you have to flush it with fresh
water before you use it again.
Flush the machine in the following way:
1 Fill the water reservoir with cold water up to the MAX indication and put it
back into the machine. (Fig. 3)
2 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machine
without pod(s). (Fig. 12)
3 Put a bowl (with a capacity of at least 1500 ml) under the coffee spout to
collect the water. (Fig. 8)
4 Press the on/off button 3 (1) and subsequently press buttons the 1-cup
button q and the 2-cup button qq briefly at the same time (2). (Fig. 28)
coffee later, just leave the
\
The machine fills itself with water from the water reservoir. While this happens,
water comes out of the spout. When the flushing cycle is finished, the
machine switches itself off. During the flushing cycle, the machine produces more
noise than during a regular brewing cycle.
Descaling
Regular descaling will prolong the life of the coffee machine and will guarantee
optimal brewing results for a long time. If the machine is used twice a day on average,
it must be descaled once every 3 months.
1 Fill the water reservoir up to the MAX indication with descaler and water
according to the instructions on the package of the descaler. Then put the
water reservoir back into the coffee machine. (Fig. 3)
Use a liquid descaler based on citric acid.
2 Press the on/off button 3. (Fig. 11)
The machine is ready for use when the indicator light burns continuously.
3 Place the 1-cup pod holder q in the coffee machine, preferably with a used
coffee pod in it. Close the lid and make sure it is properly locked.
We advise you to put a used coffee pod in the pod holder when you descale the
machine. This pod will serve as a 'filter' to prevent the sieve in the pod holder from
getting clogged with scale residues.
4 Put a bowl with a capacity of at least 1500 ml under the spout openings to
collect the mixture of descaler and water. (Fig. 8)
5 Press the 2-cup button qq and let the machine operate. Repeat this until the
water reservoir is empty. (Fig. 29)
Never descale the SENSEO coffee machine with the lid open. Make sure the lid is
\
properly locked.
6 Repeat steps 1 to 5 with a new mixture of descaler and water.
7 Empty the water reservoir to remove the mixture of descaler and water.
8 Rinse the machine at least 3 times by repeating steps 1 to 5, now using fresh
water.
Do not refill the water reservoir with used hot water.
,
9 Clean the pod holder after descaling to prevent the sieve in the centre from
getting clogged.
Frost-free storage
If the coffee machine has already been used and therefore has been flushed with
water, it may only be used and stored in a frost-free place to prevent it from
becoming damaged.
Replacement
All removable parts can be orderd from your Philips dealer or a Philips service centre.
Environment
Do not throw the machine away with the normal household waste at the end
,
of its life, but hand it in at an official collection point for recycling. By doing this
you will help to preserve the environment. (Fig. 30)
Guarantee & service
If you need service or information or if you have a problem, please consult the
worldwide guarantee leaflet or visit our website at www.philips.com. You can also
contact the Philips Customer Care Centre in your country; they will be happy to help
you.
For the UK and Ireland the telephone numbers are:
- United Kingdom: 0906 1010016 (GBP 0.15/minute)
- Ireland: 01 764 0264 (National rate)
You will find the telephone numbers for other countries in the worldwide guarantee
leaflet. If there is no Customer Care Centre in your country, turn to your local
Philips dealer or contact the Service Department of Philips Domestic Appliances
and Personal Care BV. You will find their address and fax number in the worldwide
guarantee leaflet.
The purchase of the Philips SENSEO
rights of Sara Lee/Douwe Egberts or Philips under any of their patents nor does it
confer upon the purchaser a licence under these patents.
coffee machine does not exhaust any of the
\