Displacement Pump - Graco GM5000HD Instructions Manual

WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
whenever you are instructed to relieve
pressure, follow the Pressure Relief
Procedure on page 10.
Removing the pump.
1. Relieve pressure.
2. Flush the pump. See page 11
3. Remove the hose (55). Remove the two spring
clips (74, 80) and drain hose (76).
4. Push the retaining spring (26) up. Push the pin
(25) out the rear.
5. Loosen the locknut (27). Unscrew the pump.
25
27
28
Fig. 21

Displacement Pump

(See Fig. 21.)
26
55
80, 74
76
7179A
Repairing the pump.
See manual 307–806 for displacement pump repair.
Installing the pump.
1. Screw the pump about 3/4 of the way into the
bearing housing (21). Hold the pin (25) up to the
pin hole on the connecting rod (22) and continue
screwing in the pump until the pin slides easily into
the hole.
2. Back off the pump until the top threads of the
pump cylinder are flush with the face of the bear-
ing housing and the outlet nipple faces back.
3. Push the retaining spring (26) into the groove all
the way around the connecting rod. Tighten the
locknut (27) to 90 5 ft-lb (122 6.8 N m) using a
wrench and a light hammer.
4. Connect the pump outlet hose. Install the suction
tube parts. Install the spring clips and drain hose.
The face of the bearing housing.
Torque to 90 5 ft-lb (122 6.8 N m)
25
22
26
Fig. 22
(See Fig. 22.)
21
27
0031