Kurzweil V150 Owner's Manual page 55

Caution: Installing an operating system or sounds involves doing a hard reset, which erases the
V150/V110's user-defined memory (like your Panel Memories). If you want to save these, you
should do so before you begin to install the operating system or sounds. See page 3-17.
1. Select
2. Select
3. Start playing the MIDI file from the sequencer. While loading, the bottom line of the
V150/V110's display will show a message
counts up to the total number of segments, which is represented by
continues to show
sequence.
4. Depending on the size of the file, it may take several minutes to load, at which point the
bottom line of the display will show
that file from the sequencer and start playing it.
5. After you have completed loading all of the MIDI files (except a boot block file), press the
display button labeled
Right or Left buttons to scroll to the
display button labeled
restart with the new operating system.
Installing a New Boot Block
If the file you are loading is a boot block file with the letter b as the fourth letter in the filename,
follow instructions in Setting Up For a Software Upgrade on page A-2, then continue:
1. Scroll to
2. Select
3. Start playing the MIDI file from the sequencer. While loading, the bottom line of the
V150/V110's display will show a message
show
4. After about a minute, the V150/V110 will reset and start running normally.
Resetting the V150/V110
If you select
display will ask
about what you are doing. This resets all of the V150/V110's memory back to the initial factory
state. This is necessary if you are upgrading the software. If you're not concerned about losing
all of your Panel Memories, or if you've saved them using a MIDI Sysex dump (see Saving Panel
Memories on page 3-17), then press the display button labeled
a hard reset and start running normally.
Running the Diagnostics
The Run|diags
tests will erase the V150/V110's memory, which will cause a hard reset when the V150/V110 is
powered on again. Turn your V150/V110 off then on again to leave Diagnostics mode and
return to normal operation.
by pressing the display button labeled
Install|engine
via|MIDI by pressing the display button labeled
waiting|for|MIDI
Cancel
Enter
Update|boot|block
via|MIDI by pressing the display button labeled
after starting the sequencer, stop and restart the sequence.
waiting|for|MIDI
HARD|RESET by scrolling and pressing the display button labeled
Erase|RAM|objects?
option executes the V150/V110's internal diagnostic tests. Some diagnostic
segment|X|of|Y
after starting the sequencer, stop and restart the
done . Then, if you have another file to load, open
twice to get back to the main boot block menu, use the
menu item, and select it by pressing the
HARD|RESET
. Press the display button labeled
and select by pressing the display button labeled
segment|1|of|1
which gives you an important opportunity to think
Maintenance and Upgrades
.
Enter
Enter .
where starts at 1 and
X
. If the display
Y
; the V150/V110 will
Yes
Enter .
. If the display continues to
Enter
Yes . The V150/V110 will execute
Boot Block
.
Enter
, the
A-3