Draining The Bilge Water On Water - Yamaha 210FSH SPORT 2022 Operator's Manual

Engine compartment
1 Fuel tank compartment drain plug
To drain the bilge water from the hull:
Remove the hull drain plug at the stern to
drain the water. Check the condition of the
O-ring on the hull drain plug, and then se-
curely install the drain plug.
1 Hull drain plug

Draining the bilge water on water

This model is equipped with a self-draining
deck and bilge pump to drain the bilge water
on water.
Self-draining deck
Most water that enters the deck area drains
automatically out the stern through the large
drain holes in the deck.
A one-way check valve in each drain pre-
vents water from traveling back to the deck
Operation and handling requirements
1
1
while the boat is moored or moving in re-
verse.
Bilge pump
Your boat is equipped with a drainage sys-
tem that channels water that enters the boat
from the storage compartments to the bilge
under the engine compartment.
When the bilge pump switch is turned on, the
bilge pump will operate.
1 Bilge pump switch
Even if the bilge pump switch is not turned
on, the bilge pump will detect when there is
excessive water in the bilge and will automat-
ically drain most of it through the bilge pump
outlet. This function works automatically,
even if the battery switches are turned to the
off position.
1 Bilge pump outlet
LIVEWELL BILGE HORN
1
1
82