Table of Contents
Advertisement
q
e
z x c
e
r
r
e
d1–d4
w
r
q
w
r
d6–d9
Darning
Machine settings
q Pattern:
w Thread tension:
e Presser foot:
r Foot pressure:
z Attach the automatic buttonhole foot R and pull the
button holder all the way out.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
q Button holder
w Starting point
x Start the machine and sew to the required length, then
press the reverse button. This sets the darning length.
Continue sewing until the machine stops automatically.
e Reverse button
r Required length
c Sew another layer of darning over the first layer, at a
right angle to it.
NOTE:
The maximum darning length is 2 cm (3/4˝) and the
maximum width is 0.9 cm (3/8˝).
To sew the same size darning
When finished sewing, a confirmation message will
appear.
Simply start the machine to sew another darning in the
same size.
To sew the next darning in a different size, press the
memory key.
To sew a shorter darning
Sew the first line to the desired length and stop the
machine.
Press the reverse button and start the machine again.
The machine will sew the rest of the darning and stop
automatically.
To adjust the evenness of darning stitches
You can correct unevenness of darning stitches by
pressing the "–" or "+" key of the stitch length adjusting
key.
If the left corner is lower than the right side, press the "–"
key to correct it, and vice versa.
NOTE:
The evenness can be adjusted within d1 to d9
(default setting is d5).
68
35
AUTO
Automatic buttonhole foot R
5
Advertisement
Table of Contents
