Sanyo VDC-HD3500P User Manual page 18

Follow the steps below to set up and connect the camera to your PC.
You can use alarm video recording, bidirectional audio communications, and other standard features of the
camera, in addition to normal live video monitoring.
1
Install an SD memory card into the SD card slot.
The SD memory card must be formatted before use.
2
Connect the power cable to the power terminals.
Use a 24-VAC or 12-VDC power supply.
Do not turn on the camera until you complete all connections.
3
Connect the network (LAN) socket to your PC using a LAN cable.
Check the operating environment of your PC and perform the following operations:
Check the network information on your PC.
Install the "H.264 Plug-in" from the supplied CD-ROM onto your PC.
4
Connect a microphone and a speaker system to the audio input and output jacks of the
camera.
AUDIO IN jack: Use this jack to connect an external microphone to hear the sound with live video, or
simultaneously record the video and sound.
AUDIO OUT jack: Use this jack to connect an amplified speaker system to send audio messages from your
PC to the camera.
5
Connect the desired external devices to the alarm input/output cables.
ALARM IN1/2 cable: Connect an external switch, infrared sensor, or other device to detect alarm conditions
such as the entry of an intruder.
ALARM OUT 1/2 cable: Connect a buzzer, lamp, or other alarm device to output a signal that indicates the
occurrence of an alarm condition.
Quick Operation Guide 2/13