Inserting An Sd/Mmc Memory Card; Charging The Battery; Turning On - Sanyo VPC-E1075 Instruction Manual

16 Camera Setup

Inserting an SD/MMC Memory Card

The camera features 16 MB internal flash memory but you may also use an optional
SD/MMC memory card for additional storage.
Follow these instructions to insert the SD/MMC card.
1. Open the battery com-
partment on the left of
the camera.
2. Insert the SD/MMC card
into the memory card
slot as shown. (Label
side up)
3. Close the battery
compartment.
To remove the SD/MMC card, gently push the card until it
pops out. Pull out the card carefully.
Note:
Please don't take in and out the SD card while camera is processing. It will make unexpected
error or image damaged.

Charging the Battery

Insert the battery into the battery charger as shown
(Label side down). Connect the power supply to the
charging unit and the mains supply.

Turning On

Press and hold the Power button to turn on the camera. To turn off the camera,
press the Power button again.
Inserting an SD/MMC Memory Card