Advertisement
4. Double-click the IP address and then the system will pop up the web
4. Double-click the IP address and then the system will pop up the web
browser to connect IP-CAM . IE browser will download the Active X
browser to connect IP-CAM . IE browser will download the Active X
control. After downloading, a login window will pop up as shown
control. After downloading, a login window will pop up as shown
below:
below:
Input the user name and password to log in.
Input the user name and password to log in.
Default user name: admin / Default password: 123456.
Default user name: admin / Default password: 123456.
Directly Access Through a Web Browser
Directly Access Through a Web Browser
The default network settings are as shown below:
The default network settings are as shown below:
IP address: 192.168.226.201 HTTP: 80
IP address: 192.168.226.201 HTTP: 80
Subnet Mask: 255.255.255.0 Data Port: 9008
Subnet Mask: 255.255.255.0 Data Port: 9008
Gateway: 192.168.226.1
Gateway: 192.168.226.1
You may use the above default settings when you log in the camera for
You may use the above default settings when you log in the camera for
the first time.
the first time.
1. Manually set the IP address of the PC. The network segment should
1. Manually set the IP address of the PC. The network segment should
be the same as the default settings of IP-CAM. Open the network
be the same as the default settings of IP-CAM. Open the network
and share center. Click "Local Area Connection" to pop up the
and share center. Click "Local Area Connection" to pop up the
following window.
following window.
Select "Properties" and then select Internet protocol according to the
Select "Properties" and then select Internet protocol according to the
actual situation (for example: IPV4). Next, click "Properties" button to
actual situation (for example: IPV4). Next, click "Properties" button to
set the network of the PC.
set the network of the PC.
6
Advertisement
