Installing The Power Supply - Cisco NCS 4206 Installing

Installing the Power Supply

Table 2: Supported Hot Swapping Combinations
Interface Modules
SFP Combo IM—8-port Gigabit Ethernet (8X1GE) +
1-port 10 Gigabit Ethernet (1X10GE)
8-port 10 Gigabit Ethernet Interface Module (8X10GE)
1-port 100 Gigabit Ethernet Interface Module (1X100GE)
2-port 100 Gigabit Ethernet Interface Moduele (2X100 GE)
2-port 40 Gigabit Ethernet Interface Module (2X40GE)
1-port OC48
+ 4-Port T3/E3 CEM Interface Module
8/16-port 1 Gigabit Ethernet (SFP/SFP) + 1-port 10 Gigabit Ethernet (SFP+) /
2-port 1 Gigabit Ethernet (CSFP) Interface Module
48-port T1/E1 Interface Module
48-port T3/E3 Interface Module
1-port OC-192 Interface Module + 8-port Low Rate Interface Module
1
Installing the Power Supply
The Cisco NCS 4206 provides the choice of two different power supplies:
• DC power
The DC power supply provides option to connect with two different sources (dual feed); positive (+) and
negative (-) are marked on the PSU terminals.
Each power supply provides a dual primary input power connection.
Caution
Installing the Cisco NCS 4206
22
1
/ STM-16 or 4-port OC-12/OC-3 / STM-1/STM-4 + 12-port T1/E1
Any of the 4 ports can be used as an OC48, but if a port is configured as OC48, then the remaining 3
ports are disabled.
• 900 W DC power: –40VDC to –72VDC
The power supply must be wired before plugging the power supply in the chassis. Ensure the branch circuit
breaker is turned off. Only after installing the power supply in the chassis, should the branch circuit breaker
be turned on. The branch circuit breaker must be turned off before unplugging the power supply.Read the
installation instructions before connecting the system to the power source. Statement 10
Installing the Cisco NCS 4206
NCS420X-RSP
Cisco IOS Release 3.18
Swapping allowed on all
Ethernet interface modules
No support
No support
No support