Vector OPA2-VC Technical Data

OPA2-VC
Communicating Operation terminal
Features
• Display and change of operation state and set points
• Display input values according to real values not voltage signals
• Display and change of configuration parameters
• Integrated temperature sensor (-T)
• Surface mounting
Applications
• Configuration and operation of TCX2 controllers
• Remote supervision (RS485)
General Description
The OPA2-VC is a remote display and operation terminal for TCX2 series controllers.
Ordering
Item Name Item Code
40-50 0007
OPA2-VC
Mounting location
• Install the operation terminal on an easy accessible interior wall, approx. 1.5 m above the floor in an area of average
temperature.
• Avoid direct sunlight or other heat sources, e.g. the area above radiators and heat emitting equipment.
• Avoid locations behind doors, outside walls and below or above air discharge grills and diffusers.
• Location of mounting is less critical if external temperature sensors are used.
Installation
See installation sheet no. 70-000113C (www.vectorcontrols.com).
Dimensions
Important notice and safety advice
This device is for use as operating controls. It is not a safety device! Where a device failure endangers human life and/or
property, it is the responsibility of the client, installer and system designer to add additional safety devices to prevent a
system failure caused by such a device failure. Ignoring specifications and local regulations may cause equipment damage
and endangers life and property. Tampering with the device and misapplication will void warranty.
Doc: 70-00-0196A, V1.3, 20220222
Subject to alterations
Passive inputs
88 (3.5)
© Vector Controls GmbH, Switzerland
www.vectorcontrols.com
OPA2-VC Operation Terminal
Humidity sensor Description/Option
Operation terminal for TCX2 controller
with internal temperature sensor
21
9
(0.8)
(0.3)
Technical Data
Page 1-4