Operation - Makita DTD173 Instruction Manual

The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
1
2
3
Fig.15
► 1 . Groove 2. Hook 3. Screw
Using hole
WARNING:
Never use the hanging hole for
unintended purpose, for instance, tethering the
tool at high location. Bearing stress in a heavily
loaded hole may cause damages to the hole, result-
ing in injuries to you or people around or below you.
Use the hanging hole at the bottom rear of the tool to
hang the tool on a wall using a hanging cord or similar
strings.
Fig.16
► 1 . Hanging hole

OPERATION

The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Fig.17
The relation between fastening torque and fasten-
ing time for standard bolt (when impact force is 4)
N•m
(kgf•cm)
140
(1428)
120
(1224)
100
(1020)
80
(816)
2
60
(612)
1
40
(408)
20
(204)
1. Fastening time (second) 2. Fastening torque
16 ENGLISH
M16
M14
M12
M10
M8
0 1
1
M16
M14
M12
M10
M8
2