Zss Circuit Card; Zss Connection - Siemens milltronics ZSS Instruction Manual

ZSS Circuit Card

Notes:
For 115 V AC operation, jumpers J1 and J2 only are installed.
For 230 V AC operation, jumper J3 only is installed.

ZSS Connection

Notes:
1. Dry contacts shown in de-energized (alarm or shelf) state.
2. ZSS is manufactured for 115 or 230 V AC operation. Correct voltage must
be supplied. Voltages lower than specified will result in an inoperative
condition. Vol higher than specified will severely damage unit.
3. For 5 second time delay and minimum 12 ppm range, connect jumper
across 1TB-7/8.
Page 4
terminal block for customer connection
ZERO SPEED SWITCH
1TB
N.O.
COM
N.C.
L1
L2N
GR
5 SEC /
12 PPM
terminal circuit card
Milltronics ZSS – INSTRUCTION MANUAL
note 1
note 2
note 3
7ML19985DF01