Peavey CD Mix 9072A User Manual page 9

(40) CD/Phone inputs:
Left and right inputs are provided for output from turntables or CDs, depending
on position of the CD/Phone switch
(41) CD/Phone switch:
Selects the CD/Phone inputs to accept input from either a magnetic phono
cartridge (Phono [switch down] position) or a compact disk or other line source
(CD [switch up] position).
(42) Mic Loop - send and return:
Send and return jacks are provided for mono patching of external effects
devices, graphic equalizers, or other signal processing devices at the
microphone channel.
(43) Program Loop - send and return:
Send and return jacks are provided for stereo patching of external effects
devices, graphic equalizers, or other signal processing devices to the program
and monitor channels.
(44) Chassis ground lug:
Grounds from other pieces of equipment should be connected at this point to
minimize ground loop possibilities between power amps, outboard signal
processing units, turntables, etc.
Program outputs:
(45) Program outputs:
Two main output left and right jacks are provided for the main (program) output.
The outputs at this point should be patched out to the stereo power amplifiers
driving the main speaker system. The second pair of outputs may be used to
drive lighting controllers or for tape recording if required.
(46) Monitor outputs:
Two main output left and right jacks are provided for monitoring purposes. The
outputs at this point should be patched out to the stereo power amplifiers driving
the monitor speaker system.
Note:
It is often useful to use the monitor outputs to drive an independent
sound system for another audio zone such as a second dance floor or
background music elsewhere within the venue.
The second pair of monitor outputs may also be used to drive lighting
controllers or for tape recording if required.
(41)
on each channel. See also
(12, 13, 14)