General Operation - McCulloch MC1385 Owner's Manual

GENERAL OPERATION

NOTE: Be sure that Reservoir has been filled and that desired accessories are connected
before following these steps.
1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into a
electrical outlet.
2. Switch Lighted On/Off Switch to "On" position.
3. The pressure gauge indicates the operating pressure of the steam cleaner. Once the needle
is in the green section, the unit is ready to begin steaming. NOTE: This may take up to 15
minutes.
During use and as steam is released, pressure will drop. This may cause the needle to move
down in the green section. This is a normal condition. As long as the needle is in the green
section, the product is operating normally. If the needle is continuously in the yellow or red
section, please contact Consumer Service at 1-800-711-6617.
4. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Trigger.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Trigger.
5. Keep Steam Trigger pressed for a continuous flow of steam. You may also hold the Steam
Trigger, then push the Steam Trigger Lock to lock it down. This will allow a continuous flow
of steam without need of holding the Steam Trigger down manually. Steam output can be
adjusted by simply turning the Steam Adjustment Knob.
6. Using a back-and-forth motion over the area you are steaming will further enhance the
cleaning process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime.
Wiping the area while it is still wet is recommended, but use caution when wiping surfaces such as
metal that may still be hot.
7. Once steaming tasks are complete, turn the unit "Off" and unplug. Follow steps under Proper
Storage procedure on Page 16 of this manual.
14 | ENGLISH
Using Your Deluxe Canister Steam
System