Table of Contents
Advertisement
• Before carrying out the installation, maintenance, repair or removal
work, be sure to set the circuit breaker to the OFF position. Otherwise,
electric shocks may result.
• Place a "Work in progress" sign near the circuit breaker while the
installation, maintenance, repair or removal work is being carried out.
There is a danger of electric shocks if the circuit breaker is set to ON
by mistake.
• Only a qualified installer(*1) or qualified service person(*1) is allowed
to undertake work at heights using a stand of 50 cm or more.
• Wear protective gloves and safety work clothing during installation,
servicing and removal.
• Do not touch the aluminum fin of the outdoor unit. You may injure
yourself if you do so. If the fin must be touched for some reason, first
put on protective gloves and safety work clothing, and then proceed.
• Do not climb onto or place objects on top of the outdoor unit. You may
fall or the objects may fall off of the outdoor unit and result in injury.
• When working at heights, use a ladder which complies with the ISO
14122 standard, and follow the procedure in the ladder's instructions.
Also wear a helmet for use in industry as protective gear to undertake
the work.
• When cleaning the filter or other parts of the outdoor unit, set the circuit
breaker to OFF without fail, and place a "Work in progress" sign near
the circuit breaker before proceeding with the work.
• When working at heights, put a sign in place so that no-one will
approach the work location, before proceeding with the work. Parts
and other objects may fall from above, possibly injuring a person
below.
• The refrigerant used by this air conditioner is the R410A.
• You shall ensure that the air conditioner is transported in stable
condition.
EN-7
• Do not modify the products. Do not also disassemble or modify the
parts. It may cause a fire, electric shock or injury.
• This appliance is intended to be used by expert or trained users in
shops, in light industry, or for commercial use by lay persons.
Selection of installation location
• If you install the unit in a small room, take appropriate measures to
prevent the refrigerant from exceeding the limit concentration even if it
leaks. Consult the dealer from whom you purchased the air conditioner
when you implement the measures. Accumulation of highly
concentrated refrigerant may cause an oxygen deficiency accident.
• Do not install the air conditioner in a location that may be subject to a
risk of expire to a combustible gas. If a combustible gas leaks and
becomes concentrated around the unit, a fire may occur.
• When transporting the air conditioner, wear shoes with additional
protective toe caps.
• When transporting the air conditioner, do not take hold of the bands
around the packing carton. You may injure yourself if the bands should
break.
• Do not place any combustion appliance in a place where it is directly
exposed to the wind of air conditioner, otherwise it may cause
imperfect combustion.
Installation
• Install the air conditioner at enough strong places to withstand the
weight of the unit. If the strength is not enough, the unit may fall down
resulting in injury.
• Follow the instructions in the Installation Manual to install the air
conditioner. Failure to follow these instructions may cause the product
to fall down or topple over or give rise to noise, vibration, water
leakage, etc.
- 4 -
EN-8
Advertisement
Table of Contents
