Electrical Safety - Black & Decker BHFEA420J Quick Start Manual

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
use charger S010BHK2300040
S010BHK2300040
Features
This tool includes some or all of the following features.
1. On/off power button
2. Charging port
3. State of charge indicator
4. Dust bowl relase button
5. Clear dust bowl
6. Cyclonic filter assembly
7. Extension pole release button
8. Extension pole
9. Floorhead (with in-built floor sense)
10. Beater bar release button
11. Crevice tool
12. Charger
13. Storage station
14. Wide mouth dust brush
Assembly (Fig. A)
Align the top of the extension tube (8) with the vacuum
u
inlet (7a) as shown in Fig. A.
Push the extension tube (8) onto the vacuum inlet (7a) so
u
it locks into position.
To remove an the extension tube, press the extension
u
tube release button (7) and gently pull the extension tube
off.
Warning! When not in use position the unit with the rear of
the vacuum facing a wall so that any inadvertent fall of the unit
would contact a wall and not people or pets.
(Original instructions)
Charging the battery (Fig. B)
Warning! Use only with the supplied charger.
From new, the rechargeable cells of the product need a
minimum charge time of 5
The unit must be turned Off in order to charge.
u
Plug the jack plug (12a) of the charger (12) into the charg-
u
ing port (2) of the vacuum.
Plug the charger into a standard electrical outlet.
u
While charging, the charger may get warm, this
u
is perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely. The
charger automatically reduces power consumption
when charging is complete.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C. Follow all charging instructions
and do not charge the appliance outside of the temperature
range specified in the instructions. Charging improperly or at
temperatures outside of the specified range may damage the
battery and increase risk of fire.
State of charge indicator (Fig. C)
This appliance include a state of charge indicator (3) which
consists of three LED lights that indicate the level of charge
remaining in the battery. This feature is only activated when
the vacuum is powered on and when the vacuum is on
charge.
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack.
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only very little runtime
remaining.
Note:
The state of charge indicator is only an indication
of the charge left on the battery.
It does not indicate tool functionality and is subject to variation
based on product components, temperature and end-user
application.
Use
This vacuum cleaner can be used in one of two ways.
With the extension tube (8) and the floor head (9) as.
u
With the crevice tool (11) and the vacuum.
u
Mounting accessories
The crevice tool (11) allows for vacuuming in narrow and
u
hard to-reach places.
To attach the crevice tool (11) press into vacuum inlet (7a)
u
so it locks into position as shown in figure D.
To release the crevice tool (11) press the crevice tool
u
release button (11a) and gently pull the extension tube off.
ENGLISH
hours to ensure full power.
(Fig. D)
7