Table of Contents
Advertisement
I NS ER T I N G
B AT T E R I ES
Battery
Cover
To insert batteries use a Philips screwdriver and open 2 screws
on battery compartment. When inserting new batteries always
replace all of them and turn off Alarm before replacing.
A L A R M
C A RE
After use of Alarm in damp conditions, dry off alarm exterior
and leave to dry out somewhere warm and dry before
packing away and if not going to be used for a while it is
recommended to remove batteries in case of leakage.
P O W E R
O N
To power up the Vi Alarm.
Press Mode button for 3 seconds for
On/Off then release. When switched
Off a tone will sound. After 0.5
seconds LED lights dim blue and gets
brighter until after 3 seconds blinks to
indicate that the alarm has turned on.
The user can then let go. After turn On
the LED will light with battery level.
M O DE
A single press of the Mode button (top side button). Toggle
between volume or tone adjustment. The colour of the LED
indicates the battery level: Green - Good Battery Level
- Yellow - OK Battery Level Red - Low Battery Level, for
3 AA 1.5v
approximately 8 seconds. After 30 seconds to control will
Batteries
revert back to volume.
Good battery level
R UB BE R
STAINLESS STEEL
NUT & COMPRESSION WASHER
B UTTON
OK battery level
S OCK ET H OLD ER
When Port is not being used the
rubber socket holder should be
pressed into port. When not needed
it should be pressed into the socket
holder on reverse of Vi Alarm.
STUD WITH LOCKING
Incorporates a 3/8" stainless steel stud
with locking nut and compression
washer for attaching the alarm to
your buzz bar or bankstick. Be careful
when attaching the Vi Alarm to
banksticks, buzz bars etc. and avoid
over-tightening.
Low battery level
4
Advertisement
Table of Contents
