Murray M26-T Instruction Manual page 17

Guard Assembly
Fitting the bent shaft guard
• Slacken the fastening screw on the guard with the help of the Allen key provided and
then remove.
• Then clip the guard to the lower bent shaft.
• Screw the guard hood tightly in position with the fastening screw.
Make sure the guard is located on the housing before securing in
position.
Fig: 1
Fitting the straight shaft guard
1. Remove two screws from guard (Fig 1).
2. Position guard under the securing saddle (Fig 2).
3, Secure the two screws into the guard (Fig 3).
Fitting the carrying strap
• The strap is intended to help you work safely and ergonomically with the petrol grass
trimmer.
• Hook the strap into the fastening eyelet.
• Slip the strap over the shoulder.
• Set the length of the shoulder strap in such a way that the trimmer head runs parallel
to the ground. In order to establish the optimum length of the strap, you should then
make a few swinging movements without starting the engine.
ASSEMBL YPROCEDURES
Fig: 2 Fig: 3
17