D-Link DWA-F18 Quick Start Manual

Quick Start Guide
VR Air Bridge
Powered by Quest Link Software
DWA-F18
Contents in the box
x1
Best placement for VR Air Bridge
Use these tips to get the best performance
• In the same room as the VR headset
• Line of sight (unobstructed view between
VR Air Bridge and VR headset)
• Desk height
• Keep the VR Air Bridge vertical using the
companion stand
FCC INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio technician for help.
FCC INTERFERENCE STATEMENT
For Portable Device Usage
Radiation Exposure Statement:
The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described
in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower
output power if such function is available.
FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES)
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed
to US operation channels only.
Changes or modifications not authorized by the party responsible for compliance could void the user's authority to operate this product.
i CANADA ISED NOTICE
This device complies with ISED's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite
systems;
(ii) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask
requirement set forth in section 6.2.2.3 shall be clearly indicated.
Radiation Exposure Statement:
The product complies with the Canada portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as
described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the
device to lower output power if such function is available.
The products are compliant with SAR for general population/uncontrolled exposure limits in IC RSS-102 and has been tested in accordance with the
measurement methods and procedures specified in IEEE 1528. Maintain at least 5mm distance for body-worn condition.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated
with a minimum distance of 0.5 centimeters between the radiator and your body.
x1 x 1
Set-up
Go to oculus.com/setup to download and
1
install the Quest Link Software. For those
/
who have the software already, ensure you
are running the most recent version, if not,
update and reboot your computer.
oculus.com/setup
2
Connect the VR Air Bridge to a USB 3
port on your computer (they are blue).
/
Open the Quest Link Software and check
that VR Air Bridge is detected
Support
For more information about PC compatibility
requirements with Quest headsets, please visit
support.oculus.com
For additional support, go to:
USA - https://support.dlink.com
Canada - https://support.dlink.ca/DWA-F18
Federal Communication Commission (FCC)
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
For products available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. This equipment should be installed and
operated with a minimum distance of 0.5 centimeters between the radiator
and your body.
Drivers
Download