Table of Contents
Advertisement
Add Stitches or Letters at other Positions
If you wish to add a stitch or letter at another position in the program, move the cursor by pressing the Navigator Arrows.
The stitch or letter will be inserted to the right of the cursor.
Note: When programming letters, press the down Naviagtor Arrow to activate the cursor in the stitch program instead of in the alphabet.
Add the Same Stitch Several Times
If you want to add the same stitch several times in a row you can just press OK directly after the first stitch has been inserted.
The same stitch will be inserted each time you press OK.
You can also move the cursor to select another stitch and press OK. The selected stitch will be inserted once more to the right
of the selected stitch.
Delete Stitches or Letters
To delete a stitch in the program, select the stitch with the cursor by pressing the Navigator Arrows and press CLR.
To delete the whole program, move the cursor to the left of the first position and press CLR. A pop-up will appear asking you
to verify the deletion. Select Yes or No with the Navigator Arrows and press OK.
Add Commands
The FIX and STOP functions can be added to the program. Each command
takes one memory space in the program. To add any of the above functions to
your program just press the corresponding function on the Function Panel (see
page 23)
Note
If autofix is activated on your machine you do not need to add a FIX in the beginning
:
of the program.
Join Two Stitch Programs Into One
You can add a previously saved program to a new one in Programming Mode.
Add commands
Press Stitch Menu, select My Stitches and the program you wish to add. Press
OK and the program will be inserted in Programming Mode to the right of
the cursor.
Adjust a Single Stitch or Letter
To adjust the settings of a single stitch in a program you must select the stitch
in Programming Mode. You can adjust the stitch width, stitch length, density,
needle position or mirror the stitch. The settings for the selected stitch are
shown on the GraphicDisplay. Press ALT to toggle between different settings.
Adjust the Entire Stitch Program
Adjust a single stitch or letter
Adjustments that affect the whole program and not just single stitches, are
done in Sewing Mode. Press PROG to leave Programming Mode and switch to
Sewing Mode. In Sewing Mode you can adjust the width and length or mirror
the whole program.
There are a few things you need to know when adjusting the stitch program in
Sewing Mode:
The adjustments you make to the program in Sewing Mode can be saved to My
Stitches. However, these adjustments cannot be brought back to Programming
Mode. If you have made adjustments in Sewing Mode and press PROG to go
back to Programming Mode, these adjustments will be cancelled. This will also
happen if you load a saved program from My Stitches to Programming Mode.
Operating your Sewing Machine – 29
Advertisement
Table of Contents
