LED spotlight with
EN
motion detector
theLeda P12 WH/AL
1020941/1020942
theLeda P24 WH/AL
1020943/1020944
1. Basic safety information
WARNING
Danger of death through electric shock or fire!
Installation should only be carried out by a
¾
¾
qualified electrician!
!
Only intended for installation out of arm's reach.
!
High temperature! Do not touch the
metal parts of the device.
!
First, connect the device, then adjust the settings at the
potentiometer.
L The LED spotlight with motion detector (PIR) conforms to
EN 60598-1 and EN 60669-2-1 if correctly installed
2. Proper use
•
For entrances, single-family houses, building front, hotel
entrances, medical practices, etc.
•
For use in normal ambient conditions
•
LED spotlight is used for lighting, depending on
presence and brightness
L Lamp cannot be replaced.
Replace entire spotlight if defective!
Disposal
Dispose of device in environmentally sound manner
¾
3. Connection
WARNING
Danger of death through electric shock or fire!
Installation should only be carried out by a
¾
¾
qualified electrician!
Disconnect power source!
¾
Ensure device cannot be switched on!
¾
Check absence of voltage!
¾
Earth and bypass
¾
Cover or shield any adjacent live components
¾
Standard options
307150 01
L
N
S
Additional connection options
!
Ensure correct polarity. When ignored, the lamp flashes
permanently.
!
Protect devices in Master/Slave operation with the same
ground fault circuit interrupter.
!
Devices with PIR = Master, devices without PIR = Slave
Connection Master/Master
1
Master
L
N
S
!
The S connection must be conducted through the same
cable as the L and N line.
!
Max. 10 devices switchable as Master/Master
Several detectors can be switched at the same time by con-
necting the S terminal. If one detector detects motion, all LED
spotlight will be switched on.
Connection Master/Slave
L Optional: with Slave devices 1020741 – 1020744
L
N
S
N
L
2
Master
L
N
S
Master
Slave
L
N
S
50 m
10
Master
L
N
S
N
L
S
50 m
50 m
N
L
S
1