Specifications - Integra DTR-8.3 Service Manual

Hide thumbs Also See for DTR-8.3:
Table of Contents

Advertisement

SPECIFICATIONS

AMPLIFIER SECTION
Continuous average power output (FTC)
All channels:
110 W per channel min. RMS at 8
20 kHz with no more than 0.08%
total harmonic distortion.
145 W min. RMS at 6
driven from 1 kHz with no more
than
distortion.
Continuous power output (DIN) 150 W at 6
Maximum power output (EIAJ)
180 W at 6
Dynamic power output (stereo) 2
2
2
Total Harmonic Distortion:
0.08% at rated power
0.08% at 1 W output
IM Distortion:
0.08% at rated power
0.08% at 1 W output
Damping factor:
60 at 8
Input sensitivity and impedance
PHONO:
2.5 mV, 50 k
LINE (CD, TAPE, DVD,
VIDEO 1-5):
200 mV, 50 k
MULTICHANNEL INPUT
(FRONT L/C/R, SURROUND
L/R, SURROUND BACK L/R): 200 mV, 50 k
(SUBWOOFER):
36 mV, 50 k
COAXIAL 1, 2, 3 (DIGITAL):
0.5 Vp-p, 75
DVD, VIDEO 1, 2, 3, 4, 5:
1 Vp-p, 75
1 Vp-p, 75 (Y)
0.28 Vp-p, 75 (C)
COMPONENT VIDEO 1, 2:
1 Vp-p, 75 (Y)
0.7 Vp-p, 75 (P
Output level and impedance
Rec out (TAPE, VIDEO 1, 2):
200 mV, 470
Pre out:
1 V, 470
ZONE 2 OUT:
100 mV, 470
VIDEO (VIDEO 1, 2, MONITOR
OUT, ZONE 2 OUT):
1 Vp-p, 75
S-VIDEO (VIDEO 1, 2,
MONITOR OUT):
1 Vp-p, 75 (Y)
0.28 p-p, 75 (C)
COMPONENT VIDEO OUT:
1 Vp-p, 75 (Y)
0.7 Vp-p, 75 (P
Phono overload:
120 mV RMS at 1 kHz, 0.5% T.H.D.
Frequency response:
10 Hz to 100 kHz : +1/– 3 dB
(CD in Direct mode)
RIAA deviation:
20 Hz to 20 kHz : ±0.8 dB
Tone Control
Bass:
±10 dB at 50 Hz
Treble:
±10 dB at 20,000 Hz
Signal-to-noise ratio (direct)
Phono:
80 dB (IHF A, 5 mV input)
CD/Tape:
110 dB (IHF A, 0.5 V input)
TUNER SECTION
FM
Tuning range
USA & Canadian models:
87.50 –108.00 MHz (100-kHz steps)
Other models:
87.50 –108.00 MHz (50-kHz steps)
Usable sensitivity
Mono:
11.2 dBf, 1.0 µV (75 IHF)
0.9 µV (75
Stereo:
17.2 dBf, 2.0 µV (75 IHF)
23 µV (75
50 dB quieting sensitivity
Mono:
17.2 dBf, 2.0 µV (75 )
Stereo:
37.2 dBf, 20 µV (75 )
Capture ratio:
2.0 dB
IF rejection ratio:
90 dB
Signal-to-noise ratio
Mono:
76 dB
Stereo:
70 dB
Alternate channel attenuation:
55 dB
Selectivity:
50 dB (DIN)
AM suppression ratio:
50 dB
Total harmonic distortion
Mono:
0.2%
Stereo:
0.3%
Frequency response:
30 Hz–15 kHz, ±1.0 dB
Stereo separation:
45 dB at 1 kHz
30 dB at 100 Hz – 10 kHz
, 2 channels driven from 20 Hz to
, 2 channels
0.1%
total
harmonic
280 W at 3
220 W at 4
140 W at 8
, P
)
B
R
, P
)
B
R
DIN)
DIN)
AM
Tuning range
USA & Canadian models:
530 to 1,710kHz (10kHz steps)
Australian models:
522 to 1,611 kHz (9-kHz steps)
Usable sensitivity:
30 µV
Image rejection ratio:
40 dB
IF rejection ratio:
40 dB
Signal-to-noise ratio:
40 dB
Total harmonic distortion:
0.7%
GENERAL
Power supply
USA & Canadian models:
AC 120 V, 60 Hz
Australian models:
AC 230 –240 V, 50 Hz
Power consumption
USA & Canadian models:
8.4 A
Australian models:
670 W
Dimensions (W H
D):
435 175 460 mm
17-1/8" 6-7/8" 18-1/8"
Weight
18.2 kg (40.1 lbs)
REMOTE CONTROLLER
Model:
USA & Canadian
models:
USR-5
Australian models: USR-5RF
Hardware:
High-resolution (320 240) liquid crystal
display (LCD) with contrast control
Large touchscreen
Seven programmable direct-access buttons
Backlighting for LCD and direct-access
buttons
Infrared sending and learning eyes
3-wire (RS232) serial port connector
Software:
Dynamic, animated interface
Editable macros (up to 255 commands per
macro)
Total number of devices and macros limited
only by memory
Database with RC codes to operate different
brands
Infrared (IR):
Operating distance of 33 feet(10 meters)
Learning frequency up to 56 kHz
Learning distance 2 inch (5 cm) up to 1 foot
(30 cm)
Memory:
2 MB non-volatile flash memory (retains
commands when batteries are not present)
512 K SRAM
Batteries:
4 AA 1.5 V batteries, or one 4.8V rechargeable
battery pack (USA and Canadian model)
Battery life:
Approximately 6 months with typical use
Power management:
Power on by tapping the touchscreen, power
off automatically management
Dimensions:
6.0 inch 3.7 inch 1.7 inch
(153.6 94.1 43.7 mm)
Operating temperature: 32 ˚F to 122 ˚F (0 ˚C to 50 ˚C)
(USA & Canadian models only)
Radio
frequency (RF):
Operating distance of approximately 66 feet
(20 meters) depending on the surrounding
conditions
Band: 418 MHz
Bandwidth: +/–100 kHz
16 Extender ID's and 4 Channels
Accessories
(Not included):
Remote controller recharge package BCC-5
RF Receiver RFR-5
Database information:
Designed by UEI Technology
Licensed under U.S. Patent 5,689,353
Portions
UEI 1999
Specifications and features are subject to change without notice.
DTR-8.3

Advertisement

Table of Contents
loading

Table of Contents