Using Fast Flicks; Taking A Photo; Changing The Picture Quality - Hasbro Tiger Electronics Fast Flicks User Manual

Battery Low Detection
When the battery is Low, the last segment of the battery icon will flash. This
means you have 30 minutes to change the battery before it runs out. If the
battery does run out completely, all image and movie files along with any
settings will be cleared. We advise you to download all your files on to your
PC whenever you see this icon flashing just to make sure you do not lose any
files.
You can replace the battery when the camera is plugged to your PC via the
USB port. Because the PC powers the camera via the USB port, no files or
settings will be lost during the changing of the batteries.
Important: All memory will be erased and TV settings will be reset to default
once the On/Off switch is turned to the off position.
To save battery power always turn your camera off at the on/off switch.
This will save battery power but the internal memory will be erased and the
TV settings will be reset to default.

Using Fast Flicks

Preparing to take a photo.
Just put in the batteries, turn the slide switch from off to on and press the
Power button once, and you are ready to shoot! The LCD display will look
like this.

Taking a photo

When the unit is turned on, press the shutter and it will take a photo. You will
see the film counter jump from 0 to bSY or busy to 1. You will also hear one
beep as you press the button and another to confirm the camera has saved
the picture.
3

Changing the Picture quality

If you press the Mode button once, you will see 'FEA'. Press the Select button
once, and the quality will change from Fine to Norm (Normal). Wait for about
5 seconds. The screen will go back to operating mode with the picture quality
now changed to NORM (Normal). To change to Econ, Zoom x2 and Movie
modes, follow the same process, but press 'select' two, three, four and five
times respectively.
Shooting a Movie
Fast Flicks can take up to a 30-second movie clip, which you can play back on
your PC/Mac using QuickTime (supplied on the software CD).
1. To record a movie simply select the Movie mode in the Quality selection mode.
2. Press the Mode button once, press the Select button 4 times. You will see the Movie
icon on.
3. Press Mode button until you see the film counter.
4. Once the Movie mode is set, press the shutter and hold. The unit will beep constantly.
The movie is now being taken and is saving to the internal memory.
5. After 30 seconds it will stop.
6. You can stop the movie recording at any time before it is automatically stopped.
To do this simply release the button.
7. The file size is about 980KB for the maximum movie playback time. The time can vary
from about 25 seconds to 30 seconds. The length of the movie relates to the image
information.
4