Advertisement
OPERATION
Emptying the Dust Drum
WARNING: To reduce the risk
!
of injury from accidental starting,
unplug power cord before emptying
the drum.
1. Unplug Power Cord from power source.
2. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
3. Lift Powerhead Assembly from the
Dust Drum and set aside.
4. Empty Dust Drum into a proper waste
disposal container.
Drum
Latches (2)
Dust
Drum
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Insert the larger end of the
sional
Locking
Blowing Port of the Vac. Engage the
Professional Locking Hose Latch to the
lip of the Blowing Port. The Profes-
sional Locking Hose should snap into
place.
SP7063.indb 10
Profes-
Hose
into
the
10
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING: Always wear safety
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk
!
of injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
!
blowing creates dust which might
be inhaled.
Blowing
Port
Professional
Locking Hose
Extension
Wand
(Optional)
5/17/18 4:07 PM
Advertisement
