Table of Contents
Advertisement
WIRING
WARNING:
Before starting the wiring, turn the electrical power off. If power is left
⚠
on or turned on while wiring, fire, electrical shock or other serious injury may occur.
Make sure the power supply voltage is compatible with the unit.
Do not:
•
Make sharp bends in the cables.
•
Run cables in a way that water flows into the connectors.
•
Run the data cables adjacent to radar, transmitter, or large/high current carrying
cables or high frequency signal cables.
•
Run cables so they interfere with mechanical systems.
•
Run cables over sharp edges or burrs.
•
Extend or shorten the supplied transducer or Ethernet cables. If you need extra length,
you must buy a longer Ethernet cable or a transducer extension cable.
Do:
•
Make drip and service loops.
•
Solder/crimp and insulate connections if extending or shortening the power cable.
•
Leave room around the connectors to ease the plugging and unplugging of cables.
•
Use cable ties on all cables to keep them secure.
¼ Note:
Take care not to overtighten the cable ties to avoid damaging the cables.
Wiring diagram for a single-view system:
¼ Note:
For alternative ways to connect the yellow wire, refer to page 18.
Ethernet
16
Grounding
_
+
Hide quick links:
Advertisement
Table of Contents
