IBM Ethernet Router J02M Quick Start
Figure 7: Lift the IBM Ethernet Router J02M into the Rack
Reinstall Components
1.
2.
NOTE: Make sure that all empty slots are covered with a blank panel before operating
the router.
Step 4: Connect External Devices and DPC or PIC Cables
To connect external devices and DPC or PIC cables:
14
Step 4: Connect External Devices and DPC or PIC Cables
5
4
3
2
1
0
1
0
Slide each component into the chassis evenly so that it does not become stuck
or damaged.
Tighten the captive screws for each component.
Connect to a Network for Out-of-Band Management on page 15
Connect a Management Console on page 15
Connect the DPC or PIC Cables on page 15