Reinstall Components; Step 4: Connect External Devices And Dpc Or Pic Cables - IBM J11M Quick Start Manual

Table of Contents

Reinstall Components

NOTE: Make sure that all empty slots are covered with a blank panel before operating

the router.

To connect external devices and DPC or PIC cables:

Lift the chassis approximately 0.75 in. above the surface of the mounting shelves

and position it as close as possible to the shelves.

Carefully slide the router onto the mounting shelves so that the bottom of the

chassis and the mounting shelves overlap by approximately 2 inches.

Slide the router onto the mounting shelves until the mounting brackets or

front-mounting flanges contact the rack rails. The shelves ensure that the holes

in the mounting brackets and the front-mounting flanges of the chassis align

with the holes in the rack rails.

Move the lift away from the rack.

To install the router in an open-frame rack, install a mounting screw into each

of the open mounting holes aligned with the rack, starting from the bottom.

Visually inspect the alignment of the router. If the router is installed properly in

the rack, all the mounting screws on one side of the rack should be aligned with

the mounting screws on the opposite side and the router should be level.

Slide each component into the chassis evenly so that it does not become stuck

or damaged.

Tighten the captive screws for each component.

Connect to a Network for Out-of-Band Management on page 14

Connect a Management Console on page 14

Connect the DPC or PIC Cables on page 14

Step 4: Connect External Devices and DPC or PIC Cables

Table of Contents