Table of Contents
Advertisement
8. Firmware update using the USB
cable
Preparation: the latest firmware
PDR-M60
AC adapter
USB cable
Method:
1. Connect the small end of the USB cable to the
DIGITAL terminal of the camera and the large end
of the USB cable to the USB port on your personal
computer. <Refer to the photograph, DIGITAL con-
nection, on page 89 in the instruction manual>
2. Insert the AC adapter and set the mode dial to [PC
mode]. <Refer to the photograph, mode dial on
page 89 in the instruction manual>
3. Startup the update firmware FWUPLOAD.EXE.
* The update can not be performed completely if
you switch the mode dial while starting up.
* Do not perform with another application simul-
taneously.
4. The finder lamp lights in red while downloading and
[Uploading firmware... Please wait] is displayed on
the personal computer.
5. Beep sounds after finishing the download and
[Firmware successfully loaded.] is displayed on the
personal computer.
6. Pull out the USB cable after turning the power to
[OFF] and perform [DEFAULT]-[OK] of [SET-UP]
to confirm whether the firmware is updated to the
latest version. <Refer to the photograph, [SET-
UP]-[DEFAULT] setting screen>
9. Firmware update using the
SmartMedia
Preparation: SmartMedia with the latest [fware64.bin]
copied
PDR-M60
AC adapter
Method:
Be sure to turn the camera to [OFF], remove the
batteries and pull out the AC adapter before starting
update.
1. Insert the SmartMedia with the latest [fware64.bin]
copied to the camera and connect the AC adapter.
<Refer to the photograph, SM insertion, on page 30
in the instruction manual >
2. Press the shutter button while the beep sounds
continuously with the mode dial set to [OFF] to start
the update.
3. The beep sounds again after finishing the update,
and then the power turns off.
4. Pull out the SmartMedia and perform [DEFAULT] -
[OK] of [SET-UP mode] to confirm whether the
firmware is updated to the latest version. <Refer to
the photograph, [SET-UP]-[DEFAULT] setting
screen>
Note:
Do not use the SmartMedia used for the update to
shoot the image.
Do not press any buttons, move mode dial and pull
out the AC adapter before the update is finished and
the power turns off after pushing the shutter button
in the step 2.
10. Emergency update
Update is performed again after repairing when the
update have not succeeded.
Preparation: Firmware for update
PDR-M60
AC adapter
USB cable
Method:
1. Connect the small end of the USB cable to the
DIGITAL terminal of the camera and the large end
of the USB cable to the USB port on your personal
computer after removing the batteries and pulling
out the AC adapter. <Refer to the photograph,
DIGITAL connection, on page 89 in the instruction
manual>
2. Set the mode dial to [PC mode]. <Refer to the
photograph, mode dial on page 89 in the instruction
manual>
3. Insert the AC adapter with [DISP] key and [Wide]
key pushed simultaneously. <Refer to the photo-
graph, [DISP] key and [Wide] key display>
4. After blinking the finder lamp in orange, perform the
update from the procedures after 1-3) when using
the USB cable perform and from the procedures
after 2-2) when using the SmartMedia.
– 15 –
Advertisement
Table of Contents
