Dab Operation - JVC RA-E611B-DAB Instruction Manual

BestTune Display (Info.)
TM
To view further information broadcast by the station, press the MENU/INFO button, the display
will show the following information:
- <Service> Station service title.
- <Sources> If more than one source is available, press SELECT button and then press
▲ / ▼ buttons to choose the preferred source (DAB or FM), then press
SELECT button to confirm.
- <PTY> This describes the programme type that is being broadcast.
- <Freq> FM frequency or DAB channel dependent on Source.
- <Bitrate> The bitrate for a digital source (0kbps displayed for FM sources)
- <Signal> Signal strength expressed as a percentage.
Prune Invalid
This function allows you to delete all of the stations that are not available or in very poor
reception.
• To perform pruning invalid stations, press and hold the MENU/INFO button to enter into
menu.
• Press the ▲ / ▼ buttons repeatedly to select <Prune Invalid>, and then press the SELECT
button to confirm.
• Press the ▲ / ▼ buttons to select <Yes> for confirm deletion, or select <No> for exist, and
then press the SELECT button to confirm selection.

DAB OPERATION

NOTE: DAB mode is only available when BestTune is set to Off.
If the unit is connected to the mains power and then switched on for the first time, the unit will
automatically enter into the DAB mode and perform full scan. During the scan the display
will show <Scanning...> together with a slide bar that indicates the progress of the scan and
the number of stations that have been found so far.
Once the scan has finished, the unit will select the first alphanumerically found station. To
explore the found stations, press ▲ / ▼ buttons and then SELECT button to confirm selection.
DAB Scan
The DAB Scan will search for the entire DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
• To activate DAB scan, press and hold the MENU/INFO button to enter into menu, then press
▲ / ▼ buttons to select <DAB Scan>. Press the SELECT button to confirm. The display will
show <Scanning...> and a progressing slide bar.
• All the stations that have been found will be stored automatically. To explore and listen to the
found stations, press ▲ / ▼ buttons and then press the SELECT button to confirm selection.
DAB Display (Info.)
To view further information broadcast by the station, press MENU/INFO button, the display will
show the following information:
- <Service> Station service title.
- <Sources> To display the current source.
- <PTY> This describes the programme type that is being broadcast.
- <Freq> DAB channel.
- <Bitrate> The bitrate for a digital source.
- <Signal> Signal strength expressed as a percentage.
EN