JVC SP-PWM45 Instructions Manual page 14

Getting started
% Assembling the satellite speakers (TH-M65 only)
Each speaker (except the center speaker) has been divided into two
parts for shipment. Before connecting the satellite speakers, first
assemble them by following the procedure below.
Speaker section
Before assembling —
• Prepare a Phillips screwdriver.
• Take care not to drop the stand while assembling; otherwise, it
may cause damage to the floor or injury.
• Ensure enough space exists for assembly and installation.
• Spread a large, thick cloth on the floor where you assemble the
speakers, so you can protect the floor and the speaker itself.
1
Connect the speaker connectors to the
stand connectors.
• Be sure to connect the speaker connectors by matching their
sizes.
Speaker connectors
Front
Speaker section
2
Join the stand to the speaker section.
Speaker section
11
Stand
Front
Stand
Rear
Stand
This page is for
3
Fix the stand to the speaker section.
• Be sure to tighten the screws firmly.
Speaker section
Repeat the procedure from step 1 to assemble the other satellite
speakers.
NOTE
• Use the speaker after assembly is fully and correctly done.
• It is recommended to place a cushion under the speaker section.
You can tighten the screws easily by placing the speaker section
horizontally.
Stand
Screws (4)
(supplied,
M4 x 25 mm)
Cushion
(not supplied)