Table of Contents
Advertisement
6
EN
Preset
Dow nloa d
You can use this function only with the TV offering
T-V Link, etc.*
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-
wired 21-pin SCART cable. The degree of compatibility and
available functions may differ by system.
N O TES:
● In the area where no TV station transmits a PDC signal, the
recorder can perform neither auto clock set nor auto Guide
Program number set.
● If there is a power cut, or if you press
downloading or set up is in progress, it will be interrupted; be
sure to turn off the recorder power once and try again from the
beginning.
● Auto clock may not function properly depending on the
reception condition.
● When you perform T-V LINK function, be sure to use fully-
wired 21-pin SCART cable.
● On this recorder, the characters available for station's name
(ID) are A–Z, 0–9, –,
station's name may differ from those of your TV (
Downloaded from:
https://www.usersmanualguide.com/
1
2
3
2
4
5
6
8
9
7
0
4
1
?
O K
or M EN U while
*
, + and
(space). Some downloaded
When you connect the recorder and your TV via fully-wired
21-pin SCART cable (
channels by downloading preset data from your TV instead of
using the Auto Set Up function (
completed, the recorder sets the clock and Guide Program
number automatically. For details, refer to the instruction
manual for your TV.
Perform steps 1 to 3 of "Auto Set Up" on page 4 and 5 before
continuing.
PERFO RM PRESET DO W N LO AD
Press O K .
1
If you are referring to the front display panel
Press % fi to select "CH – –" and press O K or
If you are referring to the on-screen display
Press % fi to move the
highlight bar (pointer) to
"T-V LINK" and press O K
or
.
#
Preset position on the display panel increases from
"CH1"; do NOT press any button on the recorder or
remote control until the display panel shows either
the display as illustrated on page 7 or "– –:– –".
● If "– –:– –" appears on the display panel, refer to page
7.
● If you are using the on-
screen display, the T-V
LINK screen will appear.
Then the GUIDE PROG
SET screen will appear
during Guide Program
number set.
● If you press any button
on the recorder or
remote control while
downloading is in
progress, it will be
interrupted.
SET VIDEO CHAN N EL
Set the Video Channel to off manually. (
2
pg. 39).
IN ITIAL SETTIN GS (cont.)
pg. 3), you can set the recorder's tuner
pg. 4). After downloading is
AUTO SET
T-V LINK
[5 ∞ ] =
[MENU] : EXIT
[MENU] : EXIT
[MENU] : EXIT
.
#
T-V LINK
PLEASE WAIT
GUIDE PROG SET
PLEASE WAIT
pg. 44)
Advertisement
Table of Contents
