Panasonic DVD-LX110 Operating Instructions Manual page 38

Troubleshooting guide
Sound incorrect
Piercing noise comes
from the speakers.
Effects do not work.
No sound from center speaker.
No sound from other speakers.
No sound when you
change the play speed.
5.1 ch audio does not
work.
Recording
Cannot record to digital
recording equipment.
(Incorrect sound
recorded.)
Displays
" "
No On-Screen display.
"Check the disc."
"U11"
" ERROR 01"
" ERROR 02"
" ERROR 03"
"H "
stands for a number.
"Cannot display group xx,
content xx"
[ ] and [CHG] indicators
The [ ] indicator flashes
rapidly.
The [ ] indicator flashes
slowly.
The [CHG] indicator
flashes rapidly.
The [CHG] indicator
flashes slowly.
38
38
If you have connected a digital amplifier which does not include
decoder, be sure to select "PCM" in "Dolby Digital" or "DTS Digital
Surround" in "Audio" tab. (29)
None of the audio effects work when the unit is connected through
the digital optical cable and is outputting bitstream signals. (33)
Some audio effects do not work or have less effect with some discs.
H.Bass, Advanced Surround, Multi Re-master and Sound
Enhancement do not work if you have changed the play speed.
Press [CENTER SPEAKER]. (18)
Check all connections and settings. (33)
There may be a pause in sound. This is not a malfunction.
Output is 2 channels if you have changed the play speed.
This unit plays DVD-Audio in 2 channels.
You cannot record WMA/MP3.
You cannot record DVDs that have protection preventing digital recording.
You cannot record DVDs if the recording equipment cannot handle
signals with a sampling frequency of 48 kHz.
Make the following settings:
– Advanced Surround:
– PCM Digital Output:
– Dolby Digital/DTS Digital Surround:
The operation is prohibited by the unit, disc or card.
Select "On" for "On-Screen Messages" in "Display" tab. (29)
Clean the disc. (6)
You inserted a disc that has not been finalized. (10)
A problem has occurred with the battery pack. Consult your dealer.
The battery pack has been recharging for 20 hours but has failed to
recharge for some reason. Recharge again.
You are recharging in a location that is too hot or too cold. Recharge
at normal temperature [ 5 to
Trouble has occurred. The number appearing after "H" depends on
the problem. Turn the unit off and on again. Alternatively, turn the unit
off, disconnect the power source (AC or battery pack), reconnect the
power and turn the unit on again.
If the service numbers fail to clear, note the service numbers and
consult your dealer.
You are trying to play incompatible groups or content. (25)
The unit has malfunctioned. Consult your dealer.
The unit is on and the LCD is closed or the monitor mode is set to
"OFF" (No picture). Turn the unit off when you have finished.
There is a problem with the battery pack. Turn the unit on and check
the message on the LCD. (above)
Battery pack charge is low. The unit will turn off automatically after a
few minutes.
Off (18)
Up to 48 kHz (29)
PCM (29)
35 C ( 41 to 95 F)].