Table of Contents
Advertisement
6
Adjust the safety holder with the cord attached (
parts and screw the safety holder firmly into place.
≥ Screw tightening torque: 80 N0cm to 120 N0cm.
≥ The safety holder is to minimize the possibility of damage and harm, but it does not guarantee this effect.
≥ Keep the safety holders out of reach of children to prevent swallowing.
≥ Keep the screws out of reach of children to prevent swallowing.
H Screw with washer (supplied)
I Safety holder (supplied)
7
Attach this unit to the wall mount bracket.
8
Screw the safety holder onto the wall mount brackets.
≥ Screw tightening torque: 80 N0cm to 120 N0cm.
≥ The safety holders are designed to prevent the unit from falling off the wall mount bracket.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Keep the safety holders out of reach of children to prevent swallowing.
9
Attach the cord to a wall with a screw (not supplied).
≥ Make sure that the slack is minimal.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Check the strength of the installation location. The position in the wall where the screw is to be attached should be
capable of supporting over 33 kg. If the strength at any of these positions is lacking, provide sufficient reinforcement.
12), to fit the projecting
≥ The safety holder is placed
diagonally.
突起部
J Projecting part
M Screw without washer (supplied)
N Safety holder (supplied)
O Wall mount bracket (supplied)
P Wall
Q Screw eye (not supplied)
R Cord (not supplied)
K Wall mount
bracket
(supplied)
L Wall mount
holder
13
Hide quick links:
Advertisement
Table of Contents
