Related Manuals for Stanley PB-5
Summary of Contents for Stanley PB-5
- Page 1 5 - Beam Self-Leveling Spot Laser PB-5 77-119 Please read these instructions before operating the product Self-Leveling...
- Page 2 Contents DO NOT remove any warning label(s) on the housing. This instrument must only be used for leveling and layout tasks as outlined in this manual. ALWAYS make sure that any bystanders in the vicinity of use are made aware of the Safety dangers of looking directly into the laser tool.
-
Page 3: Product Description
Declaration of Conformity WARNING: Batteries can explode or leak and can cause injury or fire. To reduce this risk: The Stanley Works declares that the CE Mark has been applied to this product in accordance with the CE Marking Directive 93/68/ ALWAYS follow all instructions and warnings on the battery label and package. - Page 4 Product Overview Multi-Functional Base Laser Unit 1/4 - 20 Screw Mount Key Hole Slot for Hanging Strapping Slots Window for Up Beam Laser Keyboard Window for Left Beam Laser 5/8 - 11 Threaded Mount 1/4 - 20 Threaded Mount Fine Tune Adjustment Screws Magnet Mount Window for Right Beam Laser Window for Front Beam Laser...
-
Page 5: Specifications
Specifications Operating Instructions Battery Installation / Removal Level Beam Accuracy: ≤ 4 mm / 10 m (≤ 5/32 in / 30 ft) Up Beam Accuracy: ≤ 1.5 mm / 3 m (≤ 1/16 in / 10 ft) Turn laser unit over. Open battery Down Beam Accuracy: ≤... - Page 6 Laser Unit Multi-Functional Base 1/4 - 20 screw mount to attach laser unit. Transport lock in locked position. Laser Allows for full 360° placement of the laser power is OFF. unit. Power OFF / Locked 360° Placement Transport lock in unlocked position. Laser power is ON.
- Page 7 Applications Calibration Plumb: NOTE: The laser unit has been calibrated at the time of manufacturing. Periodically check Establish 2 reference points that need to the accuracy of the laser unit to ensure that the calibrated specifications are maintained. be plumb. Align one of the vertical laser beams to a set reference point.
- Page 8 = 0,0048 x (D ft - (2 x D ft)) calculated maximum offset distance the Compare: unit must be returned to your Stanley Rotate laser unit 180° and mark point P ≤ ± Max Distributor. Example: D = 10 m, D...
- Page 9 Place laser unit as shown with laser ON. maximum offset distance the unit must be Compare: Mark point P returned to your Stanley Distributor. ≤ Max Example: D = 10 m, D = 5.5 mm x 10 m = 8 mm (maximum allowed offset distance) 5.5 mm ≤...
-
Page 10: Maintenance And Care
Store the laser unit in its case when not in use. If storing for extended time, remove batteries calculated maximum offset distance the before storage to prevent possible damage to the instrument. Compare: unit must be returned to your Stanley Distributor. and D ≤ Max... -
Page 11: Warranty
Repair or replacement under this Warranty does not affect the expiry date of the Warranty. To the extent permitted by law, Stanley Tools shall not be liable under this Warranty for indirect or consequential loss resulting from deficiencies in this product.