Table of Contents
Advertisement
11 When the message [Press <F2> to enter SETUP] is displayed, press F2 and then
run the Setup Utility.
If the password has been set, enter the Supervisor Password.
12 Press F9 .
At the confirmation message, select [Yes] and press Enter . (The Setup Utility
settings will return to their default values. Even the security settings with the excep-
tion of the password(s) will return to their default values.)
Change the settings where necessary.
13 Press F10 .
At the confirmation message, select [Yes] and press Enter .
14 Perform the setup procedure for Windows by following the instructions on the screen.
Windows 98
Windows 2000
NOTE
When an UPDATE FD is to be created, follow the steps in the readme.txt on the
disk.(
page 17)
When [Operating System not found] is displayed, press Ctrl + Alt + Del
and perform the operations from step 11 to step 13.
If you fail to press F2 in step 11, restart the computer and perform the opera-
tions from step 11 to step 13 after finishing Windows setup procedure.
page 15
page 16
39
Advertisement
Table of Contents
