Television Operation; When Other Panasonic Products Respond To This Remote Control; Rqtv0134 - Panasonic Diga DMR-ES35 Operating Instructions Manual

Television operation

To turn the TV on/off, change the TV input mode, select the TV
channel and change the TV volume by means of this remote control,
set the remote control as follows.
Point the remote control at the TV
While pressing [Í, POWER TV], enter the code
using the numeric buttons.
e.g., 0250: press [0] > [2] > [5] > [0].
Manufacturer and Code No.
Panasonic 0051, 0250
National
QUASAR
FISHER 0154
GE 0047
GOLDSTAR 0178, 0317,
0457
HITACHI 0145
JVC 0053
LG 0178, 0317,
0457
MAGNAVOX 0054
MITSUBISHI 0150
≥Test by turning on the TV and changing channels. Repeat the
procedure until you find the code that allows correct operation.
≥If your TV brand is not listed or if the code listed for your TV does
not allow control of your TV, this remote control is not compatible
with your TV.
PHILIPS (RC-5) 0054
RCA 0047
SAMSUNG 0060, 0587,
0702
SANYO 0154
SHARP 0093, 0165
SONY 0000
SYLVANIA 0054
THOMSON 0047
TOSHIBA 0156
ZENITH 0017
When other Panasonic products
respond to this remote control
Change the remote control code on the main unit and on the remote
control (the two must match) if you place other Panasonic products
close together. When changing the remote control code, make sure
the two codes are same.
Use "1", the factory set code, under normal circumstances.
[1]
While stopped
Press [FUNCTIONS].
[2]
Select "Other
Functions" with [ ,
3 4
and press [ENTER].
[3]
Select "Setup" with [
3
4 ] and press [ENTER].
[4]
Select "Setup" with [ 3
] and press [ , ].
4 2 1
[5]
Select "Remote Control Code" with [
press [ENTER].
[6]
Use [ , ] to select the code (1, 2 or 3) and
3 4
press [ENTER].
≥The code on the unit has been set.
[7]
While pressing [ENTER], press and hold for
about 2 seconds the numeric button ([1], [2] or
[3]) corresponding to the code you selected in
step 6.
≥The code on the remote control has been set.
[8]
Press [ENTER].
∫ When the following indicator appears on the unit's
display
The unit's remote control code
Change the code on the remote control to match the main unit's
code (l step 7).
∫ To return to the previous screen
Press [RETURN].
∫ To exit the screen
Press [RETURN].
FUNCTIONS No Disc
No Disc
Program
]
Setup
Copy
Other Functions
ENTER
,
RETURN
,
, ] and
3 4
19

RQTV0134