Husqvarna RS 7400 D Operator's Manual page 32

FiG. 3
BlADe SHAFT BolT & WASHER: Use to tighten the
2A.
outer flange against the diamond blade.
2B. oUTeR FlAnGe: Use to hold the diamond blade
in position.
2C. oUTeR FlAnGe ARBoR: Use to support the
diamond blade.
2D. loCkinG Pin: Use to prevent the diamond blade
from rotating on the shaft during operation.
2e. DiAmonD BlADe: Use as the cutting tool for
concrete and asphalt surfaces.
2F. inneR FlAnGe: Inside support used to hold the
diamond blade in position.
2i. BlADe SHAFT: Supports the blade flanges
and blade.
32
FiG. 4
WATeR VAlVe: Use to control the water supply
3A.
to the diamond blade.
3B. liFTinG BAil: The saw can be lifted from
this point.
FRonT GUiDe: Use to locate the path of the
3C.
diamond blade on the cutting line.
3D. WATeR JeT, ReAR PoinTeR: Adjust to flush
slurry out of cut.