Fig. 2 - Husqvarna RS 7400 D Operator's Manual

FiG. 1
1A. oPeRAToR'S SeAT: Operator seated here for
proper saw operation.
1B. SPeeD ConTRol leVeR: Forward advances
the saw Forward. Pulling the lever back reverses
the saw. Lever is spring-centered to neutral.
1C. PARk BRAke SWiTCH: Pushing down applies
park brake. Lift up to release and for operation.
1D. BlADe ClUTCH SWiTCH (optional): Engages
blade drive.
1e. knoB (1 each side): Allows steering wheel to be
tilted to the most comfortable operating position.
Secure both knobs before operating saw.
STeeRinG WHeel: Turns rear wheel to maneuver
1F.
the saw.
1G. WATeR VAlVe: Controls flow rate to cool the
blade.
1H. FUel Fill: Fill the fuel tank at this location.
1J. ReD PAlm SWiTCH: For emeRGenCY SToP
of the saw. Stops all systems except raise/
lower functions. Pull oUT to reset. Do Not use for
routine stopping.
Engine Start Button:
1K.
engine using this button
1l. RAiSe / loWeR SWiTCH: Located on the speed
control lever. Use to raise and lower the saw. Push
up to raise the blade; push down to lower the blade
into the cut.
1S
1K
1W
Start and Stop the

FiG. 2

WATeR SAFeTY SWiTCH: Push switch down (OFF)
1O.
to bypass the water safety switch while starting
saw. Raise to up position during operation.
1P. liGHT SWiTCH: Pull switch up to turn on lights.
enGine KEY SWiTCH:
1R.
Power on control panel.upplies power to
the control panel for operation. Key must be
turned off when not running.
CONTROL PANEL: Shows status of the
1S.
Digital screen display.engine, rpm,
temperature, and
See control panel manual for more details.
1U. CoVeR FoR ACCeSS To BATTeRY: Provides
access to battery using rubber hood fasteners. Saw
shipped with Positive battery cable disconnected.
1V. WATeR inleT: Connects to 3/4" garden hose for
fresh water supply through oil cooler to the blade.
ENGINE RPM INCREASE/DECREASE: Buttons
1W.
to increase and decrease engine rpm
1X. SeRiAl no. DeCAl: External Serial No Decal. A
second Decal is inside Battery Access Cover (1U).
299