Table of Contents
Advertisement
Example 7-3
Show Device
P08>>> show device
polling for units on isp0, slot 0, bus 0, hose0...
dka200.2.0.0.0
DKA200
dka400.4.0.0.0
DKA400
polling for units on isp1, slot 1, bus 0, hose0...
dkb300.3.0.1.0
DKB300
dkb500.5.0.1.0
DKB500
dkb600.6.0.1.0
DKB600
polling for units on isp2, slot 4, bus 0, hose0...
dkc100.1.0.4.0
DKC100
dkc200.2.0.4.0
DKC200
dkc300.3.0.4.0
DKC300
polling for units on isp3, slot 5, bus 0, hose0...
dkd400.4.0.5.0
DKD400
dkd500.5.0.5.0
DKD500
Use the show configuration command to see a listing of the mod-
1
ules in the system. This command shows the module TLSB and PCI
slot number, module name, module type, revision, mnemonic, and if
self-test passed.
The show device command displays information about each I/O de-
2
vice. Polling checks all I/O buses for device configurations. The next
line contains the console device name, the name of the device given
by the device controller, and the device type. Example 7-3 shows
polling of only the internal bus of a KFTIA.
The show network command, not shown in the example, displays
3
information about network connections.
Using these commands (show configuration, show device, and show
network), make sure all devices and system resources are present and
"seen" by the console. Check the results of the two console commands
against the manufacturing system manifest. If something is missing, it is
likely broken, needs reseating, or is back ordered.
For more information:
Operations Manual
2
Diagnostics and Utilities 7-11
RZ26L
440C
RZ26L
440C
RZ26L
440C
RZ26L
440C
RZ26L
440C
RZ26L
440C
RZ26L
440C
RZ26L
440C
RRD44
0000
RZ26L
440C
Advertisement
Table of Contents
